Blendtec ES3 Guia do Utilizador

Home Blender User Guide(International)

10 ▶If you are not using your jar daily, before each use, reach under the bottom of the jar and turn the drive shaft for a few seconds� This will help

11during a blend cycle� When the “PULSE” button is pressed the current cycle pauses and the pulse begins� When the “PULSE” button is released, the sel

12Figure 3 - Blend Cycles*Beverages CategoryDrinks/Ice Cream CategoryWhole Foods CategoryFood Processing CategoryMulti-Use CategorySmoothieIced Cappu

136.4 RESTORING FACTORY DEFAULTSThe Blendtec Home blender has the following blend cycles set as factory defaults for preset buttons numbered 1, 2, 3,

147.2 NOISE LEVEL CHANGESIf the blender noise level has increased significantly from original levels, determine whether the sound is coming from the bl

15INSTRUCTIONS THAT APPEAR IN THIS USER GUIDE ARE NOT MEANT TO COVER EVERY POSSIBLE CONDITION OR SITUATION THAT MAY OCCUR. GOOD JUDGEMENT MUST BE USE

16

17

18

19

1206 South 1680 WestOrem, UT 84058801-222-0888blendtechome�com©2011 K-TEC, Inc�, All Rights Reserved Blendtec is a registered trademark of K-TEC, Inc�

Table of ContentsSECTION 1 - IMPORTANT SAFEGUARDS �����������������������������������4SECTION 2 - UNPACKING ������������������������������������������

4SECTION 1 - IMPORTANT SAFEGUARDSIMPORTANT INFORMATIONRead all instructions carefully before using your Blendtec® blender�1.1 SAFETY CERTIFICATIONThe

51.6 NEVER PUT NON-FOOD ITEMS INTO JARMetal utensils, rocks, and glass are dangerous if placed in jar� Damage caused by such foreign objects will void

61.15 TURN THE POWER SWITCH OFF WHEN NOT IN USEThe Power Switch (ON/OFF switch) is located on the back of the blender motor cover�1.16 AVOID TOUCHING

72.2 RECORDING YOUR SERIAL NUMBER AND DATE OF PURCHASEYour serial number is located on the bottom of the motor base� Record your blender motor serial

8Figure 2 Side View MOTOR BASE AND JAR ASSEMBLYFigure 1 Front ViewMOTOR BASELidJarBladeMotor Base CoverPower SwitchPower CordBlender Drive SocketTouch

9SECTION 4 - INSTALLATIONPlace blender on a flat, clean, and dry surface�Make sure a plug outlet is available within 2 feet (0�61 meters) of the blende